The Old Skirt section

This is for the original Thingiverse version - I suggest downloading the new skirt from Franks improved parts.

Glue the upper and lower skirt sections together. I used super glue. I usually use a drop of CA accelerator. (not a squirt or spray that will pollute the model and might cause future joints to cure instantly, get the smallest dropper you can find)   Sand the seams and surface after gluing if necessary.

Glue an oil seal(bump ring) into each hole with CA(super glue). You will notice that the 2 front lower holes (nostrils?) are larger than the rest. There is still enough of an indent ledge to glue a ring to. Fill the openings around the 2 problem rings, I used water based white DAP plastic wood or Elmers Probond filler in a tube, not a can.